Faber STRATUS NB STRTIS36WHNB Instrucciones De Instalación Información De Uso Y Cuidado página 30

Installing the Battery
• The remote control is powered by a CR2032 type 3 V battery (not included).
• Remove the screw and install the battery.
• Check that the battery is installed with the " + " side up.
Caution:
• Do not place the remote control near heat sources.
• Do not discard the batteries with normal waste, they must
be put into the specific containers.
• Make sure the battery compartment is screwed down flat
and is fully tightened..
Motor On/Off.
-
-
Lights On / Off.
Press for 2 seconds to Activate Dimmer.
Activates/Deactivates Intensive operation
Brief pressure: Activates/Deactivates the Delay function: automatic switch-off with a 30' delay. The
display shows the operating speed and the dot at the bottom right flashes once a second.
Increases the working speed each time it is pressed
Decreases the working speed each time it is pressed
30
Remote control information
Remote Control control panel