Burnishing With The Drive Model - Nobles SpeedGleam Manual Del Operador

OPERATION
3. Slowly push the machine forward to begin
burnishing.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
4. Press the pad pressure switch to increase (+)
or decrease (--) the pad pressure. Adjust the pad
pressure so that the pad pressure meter reads
within the green zone (Figure 11).
ATTENTION: Do not operate the machine with the
pad pressure meter adjusted in the red zone, floor
damage and brush motor overload will result.
FIG. 11
NOTE: If machine vibrates, remove pad and realign.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
5. To stop burnishing, release the triggers. The pad
will automatically raise to the transport position.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.

BURNISHING WITH THE DRIVE MODEL

1. Turn key on, if equipped, then turn the main power
and pad switches to the ON position (Figure 12).
FIG. 12
2. Turn the speed control knob to the slowest setting.
This will prevent an abrupt take off (Figure 13).
10
FIG. 13
3. Pull the trigger switches to begin burnishing. The
machine will slowly begin to move forward and the
pad will automatically draw to floor and begin to
spin. To increase the speed, gradually turn the
speed control knob to the desired speed
(Figure 14).
FIG. 14
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
4. Press the pad pressure switch to increase (+)
or decrease (--) the pad pressure. Adjust the pad
pressure so that the pad pressure meter reads
within the green zone (Figure 15).
ATTENTION: Do not operate the machine with the
pad pressure meter adjusted in the red zone, floor
damage and brush motor overload will result.
FIG. 15
Nobles SpeedGleam/Plus (01- -05)