Burnishing With The Drive Model - Nobles SpeedGleam Serie Manual Del Operador

OPERATION

BURNISHING WITH THE DRIVE MODEL

1. Turn key on, if equipped, then turn the main power
and pad switches to the ON position (Figure 11).
FIG. 11
2. Turn the speed control knob to the slowest setting.
This will prevent an abrupt take off (Figure 12).
FIG. 12
3. Pull the trigger switches to begin burnishing. The
machine will slowly begin to move forward and the
pad will automatically draw to floor and begin to
spin. To increase the speed, gradually turn the
speed control knob to the desired speed
(Figure 13).
FIG. 13
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
10
Home Find... Go To..
4. Press the pad pressure switch to increase (+) or
decrease (–) the pad pressure. Adjust the pad
pressure so that the pad pressure meter reads
within the green zone (Figure 14).
ATTENTION: Do not operate the machine with the
pad pressure meter adjusted in the red zone, floor
damage and brush motor overload will result.
FIG. 14
NOTE: If machine vibrates, realign pad.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
5. To operate machine in reverse, simply pull the
reverse trigger (Figure 15).
FIG. 15
6. To stop machine, release the triggers. The pad will
automatically raise to the transport position.
7. To transport machine, turn the pad switch off and
pull the triggers. The pad will automatically raise to
the transport position.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.
Nobles SpeedGleam/Plus (01–02)