Dyna-Glo DGA480SSP Manual Del Usuario página 11

ASSEMBLY INSTRUCTIONS
9. Attach two screws (FF) to the grill body (O) as
illustrated. Do not fully tighten screws (leave
approximately 5 mm). Align the key holes in
the left side burner assembly (P) with the two
screws (FF) just installed in the grill body (O)
and tighten screws. Insert three screws (FF) in
the remaining holes in the supports and tighten.
Align the side burner tubing with the side burner
orifice and insert the tubing into the orifice.
Use 2 screws (DD) to secure the side burner
orifice and side burner orifice support to the side
burner support. Attach the ignition wiring to the
electrode. Align the key holes on the burner tray
with the side burner cooking grate (Q) and set
in place.
Hardware Used
DD
M4 x 10 Screw
FF
M6 x 16 Screw
10. Install two screws (FF) on the grill body (O). Do
not fully tighten. (Leave approximately 5 mm).
Align the key holes in the right shelf assembly
(R) with the two screws (FF) just installed in
the grill body (O) and tighten screws. Insert
three screws (FF) in the remaining holes in
the supports and tighten.
Hardware Used
FF
M6 x 16 Screw
All manuals and user guides at all-guides.com
x 2
x 5
x 5
11
9
FF
FF
Q
10
DD
Electrode
Ignition wiring
P