Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Possible Cause
Blade binds, jams or
Saw blade damaged
shakes
Dull blade
Improper blade
Warped blade
Saw vibrates or
Saw blade damaged
shakes
Saw blade loosened
Saw not properly fastened
down
Work piece not properly
supported
Laser line projection
Light in work area is too
is hard to see
bright
Saw dust on the laser lens
Protecting the environment
Z
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Stanley Fat Max product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product avail-
able for separate collection.
z
Separate collection of used products and packag-
ing allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials.
Local regulations may provide for separate collection of elec-
trical products from the household, at municipal waste sites or
by the retailer when you purchase a new product.
Stanley Europe provides a facility for the collection and
recycling of Stanley Fat Max products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Stanley Europe office at
the address indicated in this manual. Alternatively, a list of
authorised Stanley Europe repair agents and full details of our
after-sales service and contacts are available on the Internet
at: www.2helpU.com
Technical data
Solution
Replace blade
Motor
Replace or sharpen
blade
Replace blade
Speed
Blade
Replace blade
Laser
Replace blade
Laser wavelength
Tighten arbor bolt
Laser outpower
Net weight
Fasten saw to bench,
stand or table
Cutting capacity
properly support or
clamp work piece
Move the mitre saw
to a work area with
proper light
Clean laser lens with
a soft, dry brush
Stanley Europe declares that these products described under
These products also comply with Directive 2004/108/EC and
2011/65/EU. For more information, please contact Stanley
Europe at the following address or refer to the back of the
(Original instructions)
L
(sound pressure) 99dB(A), Uncertainty (K) 3dB(A)
pA
L
(sound power) 111dB(A), Uncertainty (K) 3dB(A)
WA
Vibration total values (triax vector sum) according to EN 61029:
Vibration emission value (a
) 4.8m/s
h
EC declaration of conformity
MACHINERY DIRECTIVE
%
FME721 Sliding Compound Mitre Saw
"technical data" are in compliance with:
2006/42/EC, EN 61029-1, EN 61029-2-9
manual.
ENGLISH
FME721
230V~50Hz, 1500W S6 20%
5min
5000RPM
216mm (40 tooth) carbide
tipped
Class ll
650nm
<1mW
16.6kg
6.2 x 30.5cm crosscut at 0º
mitre, 0º bevel
6.2 x 21.5cm mitre at 45º mitre,
0º bevel
3 x 30.5 cm bevel at 0º mitre,
45º bevel
3 x 21.5cm compound at 45º
mitre, 45º bevel
2
2
, uncertainty (K) 1.5 m/s
19
Publicidad
