First Setup; Information About The Network Connection - Auerswald COMpact 5200 Manual De Instrucciones

First Setup

Connect the PBX to a freely accessible Schuko socket.
The Power and Status LEDs light up several seconds/minutes in
red and orange.
When the LEDs light up in green, the PBX is ready for operation.
Note: If the Power LED remains continuously lit in red, an error has occurred. Please contact
your dealer or the manufacturer directly.
First Setup
Warning: Incomplete or incorrect configuration can be hazardous to people, if for
example emergency calls cannot be performed.
• The configuration of the product is made via an integrated web server whose pages are
called via web browser. The user interface of the web server (Configuration Manager) is
available in English and German. If you are not familiar with these languages and the tech-
nical terms, please consult a specialist who is linguistically and professionally qualified.

Information about the Network Connection

Configuring the PBX using a PC is done using the configuration manager integrated in the
PBX. This can be accessed via the IP address of the PBX. The IP address to be used
depends on your connection and network environment.
• If the PBX is not connected to a router but is connected directly to a single PC which
receives its IP address automatically (default setting on Windows and Mac OS X), you can
access the PBX via the permanent IP address 169.254.1.240 from the APIPA address
range.
• If the PBX is connected to a router that works as a DHCP server and allocates IP
addresses to the devices connected (default setting on most routers), you can access the
PBX via two IP addresses:
1. Via the permanent IP address 169.254.1.240 from the APIPA address range.
2. Via the IP address allocated by the DHCP server.
Note: If the permanent IP address from the APIPA address range is not working, you will first
have to learn the IP address allocated by the DHCP server. You have the following options:
• If the UPnP service is installed and activated on the PC (e. g. on Windows 8), the PBX can
be found and selected in the network environment as "COMpact 5x00" device.
• You can use a network scanner (f. e. Angry IP Scanner).
Important: If you wish to operate the PBX in a network where IP addresses are allocated
permanently, you must first adapt the IP configuration of the PBX for operation in the network.
For this purpose, you must first create one of the connection and network environments
50
COMpact 5200/5200R/5500R - Instructions V01 03/2017