Updating Or Upgrading The Pbx - Auerswald COMpact 5200 Manual De Instrucciones

Commissioning (COMpact 5200R/5500R)

Updating or Upgrading the PBX

Warning: Touching voltage-carrying conductors or telephone connections can cause
life-threatening electric shocks. The PBX contains hazardous voltages, even outside
of the power supply unit (for instance ringer voltages). Work on active, contact-hazard-
ous parts is only permitted after creating a voltage-free state. Working close to active parts
is only permitted if these parts are voltage-free or are protected against direct contact .
• Pull out the PBX's power plug. Also disconnect the device from additional power sources
(e. g. UPS, if installed).
• Wait at least 3 minutes for the discharge of any capacitor in the device after disconnecting
it from the main power supply.
Caution: Electrostatic charges can destroy sensitive components.
• Discharge electrostatic charges from yourself before touching the circuit boards
with your hands or any tools. To do this, touch a preferably earthed metal object, such as
the PBX's earthing terminal or a computer case.
Important: Before you insert a COMpact 2BRI module, first make the necessary port set-
tings on the module (operating modes and terminators).
The slot on the far left (A) is exclusively reserved for the COMpact CPU module included in
the scope of supply. The slot on the far right (4) is reserved for future extensions.
Inserting a Module:
1. Slide the module into the board guides (A)
with the component side pointing to the left.
2. Press the module backward until the board
lock (B) clicks into place.
Removing a Module:
1. Unlatch the board lock, for example with your
right thumb.
2. Remove the module with your other hand.
48
COMpact 5200/5200R/5500R - Instructions V01 03/2017