Isdn Terminal At The Internal U Port - Auerswald COMpact 5200 Manual De Instrucciones

Installation
• Enabled terminators in the PBX at the internal S port in question (exception: bus wiring
0
in two directions)
operating mode "S internal"
terminators enabled
0
If PBX and terminal have a
internal S port
short distance to each other, 0
make the connection with an
ISDN cable (max. 10 m) at the
RJ-45 sockets of the internal S
0
port.
If the distance between PBX
and terminal is greater, lay the
lines fixed at the terminal
clamps of the internal S port.
0
IAE/UAE8
terminators
100 Ohm, 0.25 W
ISDN Terminal at the Internal U Port
P0
Connection possibilities:
• System telephones COMfortel 1200/1400/1600/2600 (firmware version 1.6A or later)
• ISDN telephones in accordance with the Euro ISDN Standard (DSS1)
• ISDN PC controllers in accordance with the Euro ISDN Standard (DSS1)
Requirements:
• Enabled operating mode "U internal" at the U port in question
P0 P0
57
COMpact 5200/5200R/5500R - Instructions V01 03/2017