Keysight Technologies U8030A Serie Manual De Instrucciones página 38

2 Operation and Features
Constant Voltage Operation
The following steps show you how to perform the constant voltage (CV)
operation.
1 Turn on the power supply.
2 Select an output channel.
3 Set the display to the limit mode.
When you press the [Display Limit] button, the voltage and current limit values
NOTE
will be shown on the display for about five seconds. If there is no activity
detected, the display will return to the meter mode.
38
– Press the [POWER] button to turn on the power supply.
– The power supply will then perform a self-test (self-test is not indicated at
the display).
– The display turns on all annunciators briefly.
– The outputs are disabled by default. The OFF annunciator turns on.
– The display shows OFF for both outputs (line 1 and 2).
– Press [1] to select Output 1, or
– Press [2] to select Output 2.
– The corresponding annunciator (OUT1 or OUT2) turns on.
– Press the [Display Limit] button to set the display to the limit mode. The
LIMIT annunciator turns on.
– The display will show the voltage and current limit values for the selected
output.
– The display for the non-selected output remains unchanged.
Keysight U8030A Series User's Guide