Keysight Technologies U8030A Serie Manual De Instrucciones página 55

Programming the Overcurrent Protection
Overcurrent protection guards the load against output currents reaching values
greater than the programmed protection level.
The following steps shows you how to enable and disable the overcurrent
protection (OCP), how to set the OCP trip level, and how to clear the overcurrent
condition.
Set the OCP trip level and enable the OCP
1 Select an output channel.
2 Set the OCP trip level.
3 Turn the knob to adjust the OCP value.
Keysight U8030A Series User's Guide
– Press [1] to select Output 1, or
– Press [2] to select Output 2.
– The corresponding annunciator (OUT1 or OUT2) turns on.
– Press the [Over Current] button.
– The LIMIT annunciator turns off.
– The corresponding OCP annunciator (OCP1 or OCP2) will blink
continuously.
– The display will show the OCP value for the selected output.
– The A annunciator will blink continuously.
– While the A annunciator is blinking, turn the knob and adjust to the desired
OCP value.
Operation and Features 2
55