Publicidad
Idiomas disponibles
Idiomas disponibles
English
6.2.7 INSTALLING THE SIDE OUTPUT DEFLECTOR
Raise side discharge shield, install side discharge
deflector (17).
6.2.8. FUEL
IMPORTANT: The fuel used for this machine
is highly flammable. If the fuel or the
machine ignites, put out the fire with a dry
powder extinguisher.
Petrol and oil are extremely flammable and
explosive under certain conditions. Do not
smoke and keep flames, sparks or heat
away from the machine.
Use unleaded gasoline 95 octane.
Do not use fuel that has been stored for longer than
2 months. A fuel stored for too long will cause the
starting of the machine to be more difficult and result
in unsatisfactory engine performance. If the fuel
has been in the machine's tank for longer than two
months, empty the tank and replace it with fuel in
perfect condition.
6.3.1. FILLING THE FUEL TANK
- Choose a suitable area to perform this operation.
- Remove the fuel tank cap and fill with fuel.
- Tightly close the fuel tank's cap and remove all the
fuel that spilled with a dry cloth.
WARNING:
Stop the engine before refueling.
Do not start the machine in a room or enclosure. The
exhaust gases, fumes from the fuel and oil contain
carbon monoxide and harmful chemicals. In the
case of a concentration of gases produced by poor
ventilation, remove everything that prevents the flow
of clean air from the work area in order to improve
ventilation. Do not return to work in the area until you
are sure that you have properly ventilated the area
and are clear that ventilation is sufficient as to not
happen again in this concentration
Do not refuel fuel in locations where there is the
presence of open flames, sparks or heat sources. Fill
the tank always in well-ventilated areas and with the
motor stopped. Not overflow the fuel to overfill the
fuel tank. In the event of a fuel leak be sure to remove
these leaks completely before starting, move the
machine away from the area of spillage and avoid any
source of ignition until all vapors are gone.
44/172
Publicidad
