Installation Instructions
TYPICAL INSTALLATION
Hard Water
To Outside
Faucets
Plug-in
Power
Supply
To
Controller
Valve Drain
Elbow
Valve Drain
Hose*
*Do not connect the
water softener valve drain
tubing to the salt storage
tank overflow hose.
SINGLE BYPASS VALVE
If connecting to floor level
plumbing, install the bypass
valve turned downward, as
shown.
Main Water Pipe
Overflow Drain
Elbow
Salt Storage
Tank Overflow
Hose*
Floor Drain
Figure 6
• Remove plastic shipping plug and wire from valve outlet.
NOTE: Be sure the turbine and support are firmly in place
in the valve outlet. Blow into the valve port and observe the
turbine for free rotation.
Conditioned
Water
Clips
Drain
Hose
Adapter
Inlet
Lubricated
O-ring
Secure Valve Drain Hose in
place over Floor Drain
1-1/2"
air gap
NOTE: See "Air Gap Requirements" section.
Turbine
Valve outlet
Plastic shipping plug
Turbine shaft and support
Figure 8
11
Pipe
Outlet
Bypass Valve
Figure 7
1" NPTF
Sweat
Adaptor
(not
included)
Single