Publicidad
Idiomas disponibles
Idiomas disponibles
CG 4012-CG 4016
BEFORE FIRST USE
Check that all accessories are complete and the unit is not damaged. Add water into water tank to
the MAX level and brew water for several times without coffee powder, then discard the water. Clean
all detachable parts thoroughly with warm water.
USING YOUR COFFEE MAKER
1. Open the tank cover and fill fresh water. The water level should not exceed the max level as
indicated on the water tank. Replace the tank cover.
2. Swing the funnel support out and place the filter in the funnel, and make sure it is assembled
correctly.
3. Add coffee into filter. Usually a cup of coffee need a level spoon of coffe, but you may adjust
according to personal taste.
4. Insert the jug on the keeping warm plate horizontally.
5. Plug the power cord into the outlet.
6. Pulse the switch, the indicator will be illuminated. The appliance will begin working. The brewing
process can be interrupted by pulsing the switch at any time. The appliance will continue brewing
once the switch is turned on again.
7. Note: you can take out the jug, pour and serve at any time. The appliance will stop dripping
automatically. But the time cannot exceed 30 seconds.
8. Remove out the jug to serve when finish brewing (about one minute later after the coffee stops
dripping out.)
Note: the coffee you get will be less than the water you have added, as some water is absorbed by
coffee.
Caution: When pour coffee, the momentary incline angle of the jug should not exceed 45
should pour the coffee slowly until the jug is empty, otherwise the coffee in the jug will rush to the
jug lid, and the coffee will flow out from two edges of the lid and will cause scalds.
9. When the process is finished, if you do not want to serve immediately do not unplug the power
without pulsing the switch. The coffee can be kept warm during 30 minutes and then the device will
stop. For an optimum coffee taste, serve it just after brewing.
Always turn the coffee maker off and unplug the power cord from the electrical outlet when
10.
the coffee maker is not in use.
CLEANING AND MAINTENANCE
CAUTION: Be sure to unplug this appliance before cleaning. To protect against electrical shock, do
not immerse cord, plug or unit in water or liquid. After each use, always make sure plug is first
removed from wall outlet.
1) Clean all detachable parts after each use in hot and sudsy water.
Note: the funnel can be removed from the column to cleaning. When assembling, only insert
the column of funnel into the groove of the appliance.
2) Wipe the product's exterior surface with a soft, damp cloth to remove stains.
3) Water droplets may buildup in the area above the funnel and drip onto the product base
during brewing. To control the dripping, wipe off the area with a clean, dry cloth after each
use of the product.
4) Replace all parts and keep it for next use.
°
. You
11
Publicidad
