Publicidad
Idiomas disponibles
Idiomas disponibles
32
OPErATION
OpErATiON
Operating the Dryer
1
Lint Filter
2
3
4
5
6
CLEAN THE LINT FILTER
If the lint filter has not already been cleaned, lift out the filter and remove the
lint from the last load. This will help ensure the fastest and most efficient drying
performance.
LOAD THE DRYER
Load the dryer with the wet laundry from the washer. If the load is extra large,
you may need to divide it into smaller loads for proper performance and fabric
care.
TURN ON THE DRYER
Press the ON/OFF button to turn on the dryer. The cycle LEDs illuminate and a
signal sounds, if turned on. Refer to page 10.
SELECT A CYCLE
Turn the cycle selector knob in either direction until the LED for the desired
cycle is on. The preset temperature, dry level, and option settings for that cycle
will be shown. Refer to page 33. Default settings for the selected cycle can now
be changed if desired. This can be done using the cycle modifier buttons as
shown on page 35. Cycle options can be added using the option buttons as
shown on page 35-38.
NOTE
Not all options or modifiers are available on all cycles. A different chime will
sound and the LED will not come on if the selection is not allowed.
BEgIN CYCLE
Press the START/PAUSE button to begin the cycle. The cycle can be paused at
any time either by opening the door or by pressing the START/PAUSE button. If
the cycle is not restarted within 60 minutes, the dryer will shut off and the cycle
settings will be lost.
END OF CYCLE
When the cycle is finished, the chime will sound if it is set. Remove your
clothing from the dryer immediately to reduce wrinkling. If WRINKLE CARE
is selected, the dryer will tumble briefly every few minutes to help prevent
wrinkles from setting in the clothes.
Publicidad
