LG DleX4370 Serie Manual Del Usuario página 44

44
TrOUBLEShOOTINg
Before Calling for Service (cont.)
Problem
Steam does not • Water level error.
generate but
no error code is
shown
Garments still • Too many or too different types
wrinkled after of garments in dryer.
STEAM FRESH™
There are no • The function of this cycle is to
creases left on remove wrinkles from fabric.
garment after
STEAM FRESH™
Garments have • This is normal.
static after
REDUCE STATIC
Garments are • Correct drying options not
too damp or too selected.
dry after REDUCE
STATIC
Water drips from • This is normal.
door during
Steam Cycle
Steam is not • This is normal.
visible during
Steam Cycle
Drum does not • This is normal.
turn during
Steam Cycle
Cannot see • This is normal.
steam vapor at
the beginning of
cycle
The display • MORE TIME button pressed.
shows
Odors remain • STEAM FRESH™ did not remove
in clothing after odor completely.
STEAM FRESH™
CHECK FILTER • Lint filter is almost clogged or
light is on during full.
the drying cycle
TM
FLOW SENSE • Ductwork is too long or has too
many turns/restrictions.
indicator shows
four bars during
• Significant blockage of the
the drying cycle
ductwork due to lint buildup or
or the display
debris.
shows "d75" after
• The appliance has detected a
drying.
restriction in the external dryer
venting.
Display show • Electric dryer power cord is not
error code nP connected correctly, or house
power supply is incorrect.
Possible Causes
• Unplug dryer and call for service.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
• Use an iron to make creases.
• Depends on individual moisture level in skin.
• Select load weight manually before starting REDUCE
STATIC option.
• Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
• Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the
inside of the dryer door if the steam system is operating
normally.
• The drum is turned off so that the steam vapor remains
in the drum. The drum will normally turn for about 2
seconds once a minute.
• Steam is released at different stages of the cycle for each
option.
• This display indicates that the steam option has been set
for a " " item such as a comforter.
Press the LESS TIME button to reduce the indicated load
size.
• Fabrics containing strong odors should be washed in a
normal cycle.
• Pause the drying cycle and clean the lint filter.
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the Flow Sense
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
ON/OFF button will turn off the display.
• Check the power supply or the connection of the power
cord to the terminal block.
Solutions
TM