Publicidad
Idiomas disponibles
Idiomas disponibles
10 INSTALLATION
Choosing the Proper
Location
Install the washer on a solid floor that is strong and
rigid enough to support the weight of the washer,
even when fully loaded, without flexing or bouncing.
If the floor has too much flex, you may need to
reinforce it to make it more rigid. If the floor is not
solid, it may cause severe vibration and noise.
NOTE
• Before installing the washer, make sure the floor
is clean, dry and free of dust, dirt, water and oil so
the washer feet cannot slide easily. Leveling feet
that can move or slide on the floor can contribute to
excess vibration and noise due to poor contact with
the floor.
• Allow for sufficient space between the walls and the
washer for installation.
Power Outlet
• The power outlet must be within 60 inches (1.5 m)
of either side of the washer.
• The appliance and outlet must be positioned so that
the plug is easily accessible.
• Do not overload the outlet with more than one
appliance.
• The outlet must be grounded in accordance with
current electrical wiring codes and regulations.
• Use a time-delay fuse or circuit breaker.
NOTE
• It is the personal responsibility and obligation of the
product owner to have a proper outlet installed by a
qualified electrician.
Flooring
• To minimize noise and vibration, the washer must
be installed on a solidly constructed floor.
• Allowable slope under the entire washer is a
maximum 1 inch difference from side to side or from
front to back.
• Installing on carpeting and soft tile surfaces is not
recommended.
• Never install the washer on a platform or weakly
supported structure.
NOTE
• The washer must be installed on firm flooring to
minimize vibration during the spin cycle. Concrete
flooring is best, but a wood floor is sufficient,
provided it is built to FHA standards.
Floor Installation
1"
(2.5 cm)
To ensure sufficient clearance for water lines, the
drain line and airflow, allow minimum clearances of
at least 1 inch (2.5 cm) at the sides and 4 inches (10
cm) behind the unit. Be sure to allow for wall, door,
or floor moldings that may increase the required
clearances.
32"
(81.1 cm)
28 ⅜"
(72.1 cm)
57 ¼"
(145.3 cm)
26 ¾"
(68 cm)
• Minimum vertical space from floor to overhead
shelves, cabinets, ceilings, etc., is 58 inches (147
cm).
44 ¼"
(113 cm)
27"
1"
(68.6 cm)
(2.5 cm)
3 ½"
(9 cm)
Publicidad
