Using The Vacuum Cleaner; Shaking The Primary Fi Lter; Emptying The Dust Container; At The End Of A Cleaning Session - Nilfisk DC 65GAS Manual De Instrucciones

DC 65GAS / BDC 65GAS

Using the vacuum cleaner

Once the vacuum cleaner is started, the materials can be
vacuumed.
The suction degree can be changed with the engine
accelerator lever.
Once the engine is on, it is necessary to increase the
revolutions using the accelerator lever to obtain a proper
suction degree.
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
Shaking the primary fi lter
Main fi lter operating knob
1.
Depending on the quantity of dust cleaned up, shake the main
fi lter by means of the knob (1).
WARNING!
Stop the vacuum cleaner before shaking the fi lter.
Do not shake the fi lter while the vacuum cleaner is on,
as this could damage the fi lter itself.

Emptying the dust container

WARNING!
Stop the vacuum cleaner before carrying out this
operation.
Before emptying the container it is advisable to clean the fi lter
(see "Shaking the primary fi lter" paragraph).
Dust container
1.
Dust container release lever
2.
■ Stop the vacuum cleaner.
■ Release the dust container (1) with the lever (2), then
remove and empty it.
■ Make sure that the seal is in perfect condition and
correctly positioned.
■ Place the container back in position and secure it again.
C303
[ NOTE ]
Figure 7
Figure 8

At the end of a cleaning session

■ Stop the vacuum cleaner.
■ Empty the container as described in the "Emptying
the dust container" paragraph. Clean the vacuum
cleaner as described in the "Maintenance, cleaning and
decontamination" paragraph.
■ Wash the container with clean water if aggressive
substances have been vacuumed.
■ Store the vacuum cleaner in a dry place, out of reach of
unauthorized people.
Maintenance, cleaning and
decontamination
All the maintenance, cleaning and decontamination
operations should be performed with the engine off
and by qualifi ed personnel. Failure to follow this
instruction can result in serious damages to the
vacuum cleaner and/or the operator.
The precautions described below must be taken
during all the maintenance operations, including
cleaning.
■ To allow the user to carry out the maintenance
operations, the vacuum cleaner must be
disassembled, cleaned and overhauled as far as
is reasonably possible, without causing hazards
for the maintenance staff or other people. The
suitable precautions include decontamination
before disassembling the vacuum cleaner,
adequate filtered ventilation of the exhaust
air from the room in which it is disassembled,
cleaning of the maintenance area and suitable
personal protection.
Compartments that are not dust-tight must be opened
with suitable tools (screwdrivers, wrenches, etc.) and
thoroughly cleaned.
■ Carry out a technical inspection at least once a
year, e.g.: check the air filter to find out whether
the air-tightness of the vacuum cleaner has
been impaired in any way and make sure that
the engine operates correctly. This inspection
must be carried out by the manufacturer or by a
competent person.
Use only genuine spare parts supplied and authorized
by the manufacturer.
6
WARNING!
WARNING!
WARNING!
WARNING!
07/2007