Packing And Unpacking; Maintenance And Repairs; Technical Specifi Cations; Dimensions - Nilfisk DC 65GAS Manual De Instrucciones

DC 65GAS / BDC 65GAS

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Model A (mm)
DC 65GAS
1,200
BDC 65GAS

Maintenance and repairs

WARNING!
Switch off the vacuum cleaner before cleaning,
servicing or replacing parts.
■ Carry out only the maintenance operations
described in this manual and in the engine
manual.
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action
would immediately void the EC declaration of
conformity issued with the vacuum cleaner.
WARNING!
To carry out maintenance operations which are not
described in this manual contact the manufacturer's
Service Centre or our sales network.
Technical specifi cations
Parameter
Power rating
Noise level
Container capacity
Inlet (diameter)
Max vacuum
Maximum air fl ow rate
(without hose and reductions)
Main fi lter surface
Power supply (fuel)
Fuel consumption
Fuel tank capacity
Engine oil
Engine oil quantity
C303
Figure 2
B (mm) C (mm)
700 1,700
DC 65GAS
Units
BDC 65GAS
kW 4.8
dB 100
ℓ 50
mm 70
mmH O 1,800
2
ℓ/min' 9,100
cm 19,500
2
Unleaded gasoline
Type
(for cars)
g/kWh 313
ℓ 3.6
Type SAE 10W-30
ℓ 0.6

Dimensions

Model
A (mm)
Kg
B (mm)
122
C (mm)
Kg (1)
(1) Net weight
■ Storage conditions:
Temperature: -10°C ÷ +40°C
Humidity: ≤ 85%
■ Operating conditions:
Maximum altitude: 800 m
(Up to 2,000 m with reduced performances)
Temperature: -10°C ÷ +40°C
Humidity: ≤ 85%

Controls

Dust container release lever
1.
Castor lever
2.
Manual fi lter shaker knob
3.
Engine start/stop switch
4.
Starting handle
5.
Carburettor valve lever
6.
Choke
7.
Accelerator lever
8.

Operations prior to starting

Inlet
1.
Primary fi lter
2.
Oil fi ll plug/dipstick
3.
Engine air fi lter
4.
Fuel tank
5.
Fuel fi ll plug
6.
Vacuum cleaner inspections
■ Make sure that the primary fi lter (2) is present and
correctly installed;
■ Make sure that the latches are tightly locked;
■ Make sure that the suction hose and tools have been
correctly fi tted into the inlet (1);
Do not use the vacuum cleaner if the fi lter is faulty.
4
Figure 3
DC 65GAS
BDC 65GAS
1,250
1,100
600
110
[ NOTE ]
Figure 4
Figure 5
WARNING!
07/2007