Publicidad
Idiomas disponibles
Idiomas disponibles
E
Adjust the image size (zoom)
F
Adjust the focus
G
Turn off the power
While a confirmation screen is displayed
The power cannot be turned off within approximately 90 seconds after it
has been turned on. Start operation only after 90 seconds time.
You can also press the [STANDBY/ON] button on the unit to turn off the
power. (pP11)
Put back the lens cap after use to prevent the lens from dirt.
Pull out the power plug when the unit will not be used for a prolonged time.
Smaller
Bigger
Hold and rotate the tab
Turn the ring and adjust
Blinking (Red)
Cool Down mode
Light on (Red)
ENGLISH
TIPS
You can hide the image
temporarily
You can hide the image temporarily.
Green light blinks when
the image is hidden
Press the [HIDE] button again to
display image.
The power cannot be turned off
when the image is temporarily
hidden.
MEMO
About Cool Down mode
The Cool Down mode is a function
to cool down the lamp for
approximately 60 seconds after
projection is complete.
This function prevents the internal
parts of the unit from deformation
or damage due to overheating of
the lamp. It also prevents lamp
blowout and premature shortening
of lamp life.
During Cool Down mode, the
[STANDBY/ON] indicator blinks in
red.
After the Cool Down mode is
complete, the unit automatically
returns to standby mode.
Do not pull out the power plug
during Cool Down mode. This may
shorten the lamp life and cause a
malfunction.
21
Publicidad
