EINHELL GC-KS 2540 CB Manual De Instrucciones página 19

8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Spare blade Art. No.: 34.059.30
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Troubleshooting guide
Fault
The machine does
not work
Shredding perfor-
mance unsatisfac-
tory
Anl_GC_KS_2540_CB_SPK9.indb 19
GB
Possible cause
- No power at the plug
- Machine is switched off
- Overload switch has tripped
- Ejector chute is blocked
- Loading funnel is not secure on the
motor housing
- The safety switch is not making
contact
- Blades worn
- 19 -
Remedy
- Check the power cable and fuse
- Switch on machine
- Press control on overload switch
- Clean ejector chute
- Clean interior and tighten safety
screw
- Insert the debris box correctly and
push the safety switch upwards un-
til it engages
- Turn, sharpen or replace blades
14.07.2020 09:36:59