Garland FUM 250 G Manual De Instrucciones página 27

6. START UP INSTRUCTIONS
6.1. UNPACKING AND LIST OF MATERIALS
This machine includes the following items that you will
find inside the box:
• Sprayer.
• Pressure hose.
• Gun spray.
• Suction hose.
• Return hose.
• Suction filter.
• Instruction manual.
Carefully remove all items from the box and make
sure that all listed items are present. Carefully inspect
the product to ensure that there are no damaged
elements.
If you find any damaged or missing parts, do not use
the machine until the defect has been repaired or
all the missing pieces replaced. Using the machine
without all of its parts or with defective parts can
cause severe personal injury.
6.2. ASSEMBLY
1. Install the filter at one end of the suction hose.
2. Connect the other end of the suction hose and
return to the pump hose.
Return hose
Suction hose
Filter
3. Connect one end of the pressure hose to the pump.
4. Connect the gun to the other end of the pressure
hose.
5. Insert the suction hose with filter and the return
hose in the tank that contains the liquid to be
fumigated. Make sure that the filter is submerged
in the liquid.
6.3. CHECKPOINTS BEFORE START-UP
Check the machine and look for loose parts (screws,
nuts, shells, etc.) and damage. Tighten, repair or
replace the parts you found in poor condition. Make
sure there are no leaks or loss of oil. Do not use the
machine if it is damaged or improperly adjusted.
6.3.1. MIX OF FUEL AND OIL
Use unleaded gasoline 95 octane and synthetic oil for
two stroke engines.
Engine fuel: mix synthetic oil and gasoline
(gasoline 40: oil 1 = 2.5%).
Mix gasoline and oil in an EU approved
container.
27/96
English