Garland FUM 250 G Manual De Instrucciones página 28

English
Do not use fuel that has been stored for longer than
2 months. A fuel that has been stored for too long will
cause the starting of the machine to be more difficult
and result in unsatisfactory engine performance. If the
fuel has been in the tank for more than two months,
empty the machine of the old fuel and replace it with
one in perfect condition.
Refueling in the machine:
1. Choose a suitable area to perform this operation.
2. Shake the container that has the already prepared
mixture of gasoline and oil.
3. Remove the fuel tank cap and fill with the mixture
of gasoline and oil.
4. Tightly close the cap of the fuel tank and remove all
the fuel that spilled out with a dry cloth.
WARNINGS:
Stop the engine before refueling, disconnect spark
plug, and wait for the muffler to cool.
Do not perform this operation in closed or
poorly-ventilated areas.
Separate yourself at least 3 meters from the refueling
area before starting the machine.
Never remove the cap of the fuel tank while the engine
is running.
6.4. START UP AND STOPPING THE MACHINE
Warning: The pump of this machine must not work
without liquid. Never start this machine without having
the end of the hose with its strainer submerged in
liquid spray.
Before starting the machine, make sure that the spray
gun is closed. To do thise, close the gun by turning the
knob of the diffuser cone on the gun.
6.4.1. COLD-STARTING THE ENGINE
1. Place the machine on a flat and stable surface.
2. Pump the primer of the carburetor (7 to 10 times)
several times to ensure that the fuel has reached
the carburetor.
3. Place the air level in the "CLOSED" position
4. Place the throttle at high speed.
5. Grip the machine with your left hand on the handle
and pull the Starter rope until the engine makes an
explosion or starts.
6. Place the choke in 'open' position
position).
7. If the machine has not started (you only have heard
an explosion) pull the Starter rope again until it starts.
6.4.2. STARTING WITH A WARM ENGINE
When the machine is hot ensure that the choke lever
is in the "open" position
until the engine starts. If, after a few attempts, the
machine does not start follow the steps of starting
with cold engine.
6.4.3. TURNING OFF THE ENGINE
Slow down the machine and turn off the engine.
6.5. CHECKPOINTS AFTER START UP
It is important to pay attention to the possible
individual parts and the temperature of the machine.
If you detect any anomaly in the machine immediately
stop and check it carefully.
28/96
.
(normal
and pull the Starter rope