Publicidad
Idiomas disponibles
Idiomas disponibles
Viscous liquid or slurry
If it is a non-adhesive medium, the extension pipe can be soaked in the medium
for a long time (if it cannot be corroded by liquid or foreign matters can not adhere
to the inner wall of the pipeline), so the measurement will be more accurate,
because the measurement will not be affected by other devices in the container.
The inside diameter of the nozzle should be as large as possible, and the
chamfer-ed cut should be kept smooth. The relationship between the nozzle
height L and the nozzle inner diameter φ in the following figure is shown in the
following table.
Nozzle
NO
length
1
150mm
2
200mm
3
250mm
4
300mm
5
400mm
nozzle cannot be soaked in adhesive medium
Minimum size of nozzle
Inner diameter φ
100mm
120mm
150mm
180mm
240mm
Chapter 2 Installation
Viscous liquid or slurry
Remarks
The inner wall of the nozzle
is free of burrs and bulges,
vertical from top to bottom,
and the welding seam must
be polished. The joint
between the nozzle and the
tank top shall be polished at
an oblique angle of 45℃
from the inside to the
outside of the nozzle.
- 15 -
Publicidad
