Publicidad
Idiomas disponibles
Idiomas disponibles
Chapter 4 Menu and operation
Set bias:
+00.000 m
Password setting
3.
User parameter
4.
Factory Param.
5.
Calibration
6.
Password
7.
Self-diagnosis
【SET】
▼
Fac. Setup pwd
Calibration pwd
Fac. Setup pwd
Old pwd: 0*****
New pwd: *****
【SET】
▼
- 32 -
Offset, by setting the offset, the measured
value can be offset. Setting it to a positive
number will increase the measured distance
value and a negative number will decrease
the measured distance value. The
maximum offset setting is 15m. Exceeding
this value will prompt setting failure.
In the password modification interface,
select the factory parameter password
modification by SHT key, press SET to
enter, enter the correct old password, and
then press SET. If it is correct, change the
password to the entered new password and
prompt that the password modification is
successful; otherwise, prompt that the
password modification fails and jump to the
main menu interface.
Publicidad
