Installation And Assembly - Hu-Friedy SWERV3 Manual Del Usuario

INSTALLATION AND ASSEMBLY

1. UNPACKING THE DEVICE
Upon receipt please check device for any damage caused in transit. If necessary, contact your dealer.
2. GENERAL RECOMMENDATIONS
Connect the SWERV
3
supply in accordance with current standards.
3. WATER SYSTEM SETUP
The water supply system should be of adequate quality for the practice
of dental treatment. Additionally, the water supply should be equipped
with a cut-off system. See MAINTENANCE OF THE CONTROL
UNIT: Water Line Maintenance section of this User Manual.
Connect the filter side of the water tube by inserting deep into the
water connector on the back of the SWERV
control unit. (Fig. 1)
Connect the provided water tube to the water outlet on the dental unit.
To remove the water tube from the control unit, disconnect the water
tube from the water source, then push in the grey ring of the water
connector, and gently remove the tube. (Fig. 2)
CAUTION: Be sure to insert the water tube deep into the
connector on the control unit. If water has not been used recently
at the water outlet of the dental unit, discolored water may come
out. Wait until the water coming out of the dental unit is clean
before connecting to the control unit.
4. FOOT CONTROL CONNECTION
Connect the foot control plug to the foot control
connector at the back of the control unit. (Fig. 3)
Take care to properly align all the pins. Push the plug gently
into the connector.
5. POWER CORD CONNECTION
Insert the power cord into the inlet at the back of the control unit.
(Fig. 4) Plug the power cord into the power receptacle.
6. HANDPIECE CORD CONNECTION
Align the marks on the control unit and the handpiece cord plug. Firmly
push the plug into the connector at the front of the control unit. (Fig. 5)
CAUTION:
1. Do not disconnect the handpiece cord when power to
device is switched on and the footswitch is depressed.
2. Detach insert before removing handpiece cord.
3. Grip the plug of the handpiece cord when removing.
Magnetostrictive Scaler control unit to electric
Magnetostrictive Scaler
3
SWERV
3
13
14
15
5
1
5