Operating Procedures - Hu-Friedy SWERV3 Manual Del Usuario

SWERV
6
7. START-UP
The following procedures are recommended before using your SWERV
first time:
• Clean and sterilize ultrasonic inserts. (See CLEANING AND STERILIZATION section of this User Manual.)
• Always use the proper insert frequency for your SWERV
(See table below for compatibility and see HF-464 for a complete list of Hu-Friedy inserts.)
PART CODE
UM3-30
UM3-30EU
UM3-30UK
UM3-30AU
UM3-25
UM3-25EU
UM3-25UK
UM3-25AU
• After installation operate the device at the lowest power setting while applying pressure to the foot
control. This procedure will confirm adequate water flow and rinse the internal water lines.
• Purge unit water lines (See Maintenance of the Control Unit).

OPERATING PROCEDURES

1. WATER SYSTEM SETUP
Carefully check all water supply connections prior to start-up. Open the dental unit's water valve.
Set water pressure between 0.1-0.5MPa (15-73psi). The CDC recommends monitoring dental unit water
regularly. Test water prior to connection to the SWERV
quality conforms to all applicable standards. See MAINTENANCE OF THE CONTROL UNIT: Water Line
Maintenance section of this User Manual.
2. POWER ON
Connect the power cord to the wall outlet. Turn on the power switch
on the control unit. (Fig. 6) Front panel will light up.
NOTICE: Each time the control unit is turned on, the system will
return to the default power setting.
CAUTION: Use of any wall outlets other than those of
AC120V +/- 10% or AC230V +/- 10% may result in damage
to the power cord and control unit.
3
3
Magnetostrictive Scaler.
3
30 Kilohertz
X
X
X
X
3 Magnetostrictive Scaler to confirm that input water
Magnetostrictive Scaler for the
25 Kilohertz
X
X
X
X
6