Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO ASSEMBLE THE BOWL
WARNING: Be sure the unit is unplugged before putting on or
taking off any parts. Put the bowl on top of the food processor
base, with the work bowl handle to the right. Turn the bowl
clockwise until the bowl clicks into place.
The handle should now be to the right of the control panel.
Select the appropriate attachment and assemble onto food
processor as directed in the chopping, kneading or slicing/
shredding sections. Place food or dough in bowl if using
multipurpose blade or dough blade.
NOTE: There is only one position for the bowl to lock onto the base. The unit will
not operate if the bowl does not lock onto the base.
HOW TO LOCK THE COVER
Place the lid on the bowl. Turn clockwise until the lid clicks into
place; the arrow on the lid will line up with the arrow on the
handle. Your food processor features a safety interlock system.
The unit will not operate unless the bowl and bowl cover are
properly aligned and locked into place and the large food chute
is engaged.
NOTE: Bowl must be locked into base before cover can be
locked into position.
HOW TO CHOP
CAUTION: Make sure the unit is turned off "
before use. Never use hand to push food into processor. Do
not use the processor continuously for more than 3 minutes at
a time.
Multipurpose Blade: Use multipurpose blade for chopping,
mixing, blending, pureeing and preparing puff pastry, crumbs
and short crust pastry.
1.
Lock the bowl onto base. (See "How to Assemble the
Bowl")
2.
Take the disc stem and slide it onto the center post. Then
grasp the multipurpose blade by its stem and slide over
the disc stem. (Figure 4)
3.
Place food into bowl.
4.
Lock cover onto bowl. (See "How to Lock the Cover")
5.
Place the food pusher into the feed tube.
6.
Plug the cord into an electric outlet. Use the Food Guide to prepare food for
chopping.
7.
Press the Slice/Shred "
When using the Chop/Pulse setting, hold down the Chop/Pulse "
for about 2–3 seconds at a time, check results and repeat if desired.
8.
When finished processing, press the off "
blade to stop rotating.
9.
Twist the cover counter-clockwise to remove lid.
10. Hold the disc stem with multi purpose blade attached by its stem and remove.
Unlock the bowl by turning it counter-clockwise towards the UNLOCK mark,
and lift off. Empty the processed food.
NOTE: Chopping Blade is very sharp, use caution when handling.
" and unplugged
", Mix/Knead "
", or Chop/Pulse "
" button and allow the chopping
En g lish -5
Fig. 2
Fig. 3
Fig. 4
" button.
" button
Publicidad
Tabla de contenido
