Toro Recycler 20333C Manual Del Operador página 8

Note: To raise the mower, move the front cutting
height levers rearward and the rear cutting height levers
forward. To lower the mower, move the front cutting
height levers forward and the rear cutting height levers
rearward.
1. Raise the mower
Note: The cutting height settings are 1 inch (25 mm);
1-3/8 inches (35 mm); 1-3/4 inches (44 mm); 2-1/8
inches (54 mm); 2-1/2 inches (64 mm); 2-7/8 inches (73
mm); 3-1/4 inches (83 mm); 3-5/8 inches (92 mm); and
4 inches (102 mm).
Starting the Engine
1. If the ignition switch on your mower (Figure 11)
is a toggle switch (with both an "I" and a "Stop"),
push the switch to the ("I") position. Otherwise, go
to step 2.
1. Ignition toggle switch
2. Pull the recoil starter lightly until you feel resistance,
then pull it sharply (Figure 12). Allow the rope to
return to the handle slowly.
Figure 10
2. Lower the mower
Figure 11
Note: If the mower does not start after several
attempts, contact an Authorized Service Dealer.
Using the Self-propel Drive
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace with
you (Figure 13).
Note: If the mower does not freely roll backward
after self-propelling, stop walking, hold your hands in
place, and allow the mower to roll a couple of inches
(centimeters) forward to disengage the wheel drive. You
can also try reaching just under the personal pace handle
to the metal handle and push the mower forward a
couple of inches (centimeters). If the mower still does
not roll backward easily, contact an Authorized Service
Dealer.
8
Figure 12
Figure 13