Black and Decker LSTE522 Manual De Instrucciones página 13

PROBLEM
Trimmer runs slowly.
TM
EASYFEED does not feed more line.
Overfeeding
Line unravels when cap or spool is removed.
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
Troubleshooting
SOLUTION
• Remove battery from trimmer.
• Check that the spool housing can rotate freely.
Carefully clean it if necessary.
• Check that the cutting line
does not protrude more than
approximately 4-13/16 inches
(122mm) from the spool.
If it does, cut it off so that it just
reaches the line trimmingblade.
• Keep the tabs depressed and remove the spool
from the spool housing in the trimmer head.
• Ensure that the line is not crisscrossed on the
spool as detailed in Figure U. If it is, unwind the
cutting line, then wind it back on the spool neatly so
that the lines do not cross.
• Inspect tracks at the bottom of spool for damage. If
damaged, replace spool.
• Pull the cutting line until it protrudes approximately
4-13/16 inches (122mm) from the spool. If
insufficient cutting line is left on the spool, install a
new spool of cutting line.
• Align the tabs on the spool cap with the cut outs in
the housing.
• Push the spool cap onto the housing until it snaps
securely into place.
• If the cutting line protrudes beyond the trimming
blade, cut it off so that it just reaches the blade. If the
automatic line feed still does not work or the spool is
jammed, try the following suggestions:
• Carefully clean the spool and housing.
• Make sure you are using correct line size and
diameter (0.065 inch (1.65 mm)) - smaller and
larger line sizes will affect the functionality of the
auto feed system.
• Remove the spool and check if the lever in the
spool housing can move freely.
• Remove the spool and unwind the cutting line,
then wind it on neatly again. Replace the spool into
the housing.
• Ensure you are cutting with the tip of the line (7
inches (177.8mm) from the spool).
Use the edge guide if needed to ensure proper space
is maintained.
• Ensure you are not exceeding a 10° angle as
shown in Figure J1.
• Make sure to park the lines in holding slots
(figure S) before removing.
13