Publicidad
Idiomas disponibles
Idiomas disponibles
Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for McCulloch chain saw model CS 340. This chainsaw model
equipped with either of the listed bar and saw chain combination(s), fulfills the requirements according to ANSI B175.1-
2012 (Gasoline Powered Chain Saws - Safety Requirements).
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw model McCulloch CS 340 met the kickback performance requirements of ANSI B 175.1-2012 when tested
with the combinations of bars and saw chains listed below. The saw chains McCulloch H37, Husqvarna H37 and Oregon
91PX are also classified as a low kickback saw chains since they met the requirements for low kickback saw chain
outlined in ANSI B 175.1-2012. We recommend to use only the listed combinations of bars and chains for chain saw
model McCulloch CS 340. Other chain saw models may not meet the kickback requirements when equipped with the
listed bar and chain combinations.
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the McCulloch chain saw model CS 340. The listed
combination(s) of powerhead, bar and saw chain meet all requirements outlined in Canadian Standards Association
Z62.1-11 (Chain Saws) and Z62.3-11 (Chain Saw Kickback).
Furthermore the saw chains McCulloch H37, Husqvarna H37 and Oregon 91PX are evaluated and listed as Type C Low
Kickback Saw Chain according to the provisions in Z62.3-11.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
Guide bar and saw chain combinations
The following cutting attachments are approved for the model McCulloch CS 340.
Length, inch
Pitch, inch
14
16
3/8
18
Saw chain filing and file gauges
1156553-49 Rev.2 2014-12-04
TECHNICAL DATA
Guide bar
Gauge, inch
0.050
Max. nose radius Type
McCulloch H37,
7 T
Husqvarna H37,
Oregon 91PX
Saw chain
Drive link count
52
56
62
English – 27
Publicidad
