cecotec Bolero DRESSCODE 8600 Manual De Instrucciones página 33

ENGLISH
Washing programme with longer washing time, for thorough washing.
Cotton
Hard-wearing textiles, heat-resistant textiles made of cotton or linen.
Washing programmes table
Programme Temp. (ºC) Default Time (H:M)
8.0 9.0
Synthetic 8.0 9.0
Mix 4.0 4.5
Rapid 45' 2.0 2.0
Quick 15' 2.0 2.0
Wool 2.0 2.0
Allergy care 8.0 9.0
Steam care 8.0 9.0
Rinse & spin 8.0 9.0
Spin only 8.0 9.0
Sportswear 4.0 4.5
20 ºC 8.0 9.0
Jeans 8.0 9.0
ECO 40-60 8.0 9.0
Intensive 8.0 9.0
Cotton 8.0 9.0
Warnings:
After a program is completed, wait for two minutes before opening the door.
Check whether the water inside the drum has been drained before opening its door. Do not
open the door if there is any water visible.
Never stop the device before the end of the drying cycle unless all items are quickly removed
and spread out so that the heat is dissipated.
Do not wash only one piece of clothes or garment, as these could cause great unbalance.
Always introduce at least 3 or 4 clothes so that draining can be done smoothly.
64
12.0 Default 8.0/9.0/12.0
12.0 40 3:17
6.0 40 1:20
2.5 40 0:45
2.5 Cold 0:15
2.0 40 1:07
12.0 60 2:17
12.0 40 1:47
12.0 – 0:20
12.0 – 0:12
6.0 20 0:45
12.0 20 1:00
12.0 40 1:48
12.0 – 3:32/3:41/3:56
12.0 40 3:48
12.0 40 3:39
5. CLEANING AND MAINTENANCE
Warning: Before cleaning or maintaining, unplug the appliance and close the tap.
Proper maintenance on the washing machine can extend its working life. The surface can be
cleaned with diluted non-abrasive neutral detergents when necessary. If there is any water
overflow, use a cloth to wipe it off immediately.
Fig. 25.
Do not use abrasive cleaners or scouring pads.
Cleaning the drum
The rusts left inside the drum by the metal articles shall be removed immediately with
chlorine-free detergents.
Do not use steel wool.
Note: Do not put laundry in the washing machine during the drum cleaning.
Cleaning the door seals and glass
Wipe the glass and seal after each wash to remove lint and stains. If lint builds up it can cause
leaks.
Remove any coins, buttons and other objects from the seal after each wash.
Fig. 26.
Cleaning the inlet filter
Note: The inlet filter must be cleaned when there is little water.
Washing the filter in the tap
Fig. 27.
Close the tap.
Remove the water supply hose from the tap.
Clean the filter.
Reconnect the water supply hose.
Washing the filter in the washing machine
Fig. 28.
Screw off the inlet hose from the backside of the machine.
Pull out the filter with long nose pliers and reinstall it back after being washed.
Use the brush to clean the filter.
Reconnect the inlet hose.
Note: If the brush is not clean, pull out the filter and wash it separately. Then, reconnect it and
turn on the tap.
BOLERO DRESSCODE_8600 INVERTER / 9600 INVERTER / 9600 INVERTER STEEL / 12600 INVERTER
ENGLISH
65