Publicidad
Idiomas disponibles
Idiomas disponibles
Short-term storage
Wait for engine to cool down. Keep the
machine with a full tank of fuel in a dry
place, well away from sources of
ignition, until you need it again.
Long-term storage
See "Storing the machine"
MS 192 C
Taking Care of the Guide
Bar
2
1
Turn the bar over – every time you
N
sharpen the chain and every time
you replace the chain – this helps
avoid one-sided wear, especially at
the nose and underside of the bar.
Regularly clean the oil inlet hole (1),
N
the oilway (2) and the bar
groove (3).
Measure the groove depth – with
N
the scale on the filing gauge (special
accessory) – in the area used most
for cutting.
Chain type
Picco
Rapid
Rapid
Rapid
If groove depth is less than specified:
Replace the guide bar.
N
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
3
English
Pitch
Minimum
groove
depth
3/8" P
0.20"
(5.0 mm)
1/4"
0.16"
(4.0 mm)
3/8"; 0.325" 0.24"
(6.0 mm)
0.404"
0.28"
(7.0 mm)
35
Publicidad
