Taking Care Of The Guide Bar; Air Filter System - Stihl MS 880 Manual De Instrucciones

English

Taking Care of the Guide Bar

2
1
Turn the guide bar over – every time
N
you sharpen the chain and every
time you replace the chain – this
helps avoid one-sided wear,
especially at the nose and
underside of the bar.
Regularly clean the oil inlet hole (1),
N
the oilway (2) and the bar groove
(3).
Measure the groove depth – with the
N
scale on the filing gauge (special
accessory) – in the area used most
for cutting.
Chain Chain pitch Minimum
type groove depth
Picco 1/4" P 0.16" (4.0 mm)
Rapid 1/4" 0.16" (4.0 mm)
42
Picco 3/8" P
Rapid 3/8"; 0.325"
Rapid 0.404"
If groove depth is less than specified:
Replace the guide bar.
N
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
3
0.20" (5.0 mm)

Air Filter System

0.24" (6.0 mm)
0.28" (7.0 mm)
The air filter system can be adapted to
different operating conditions by the
insertion of different air filters.
Retrofitting is simple.
HD2-Filter (black filter frame. folded
N
filter fabric) Universal filter for
almost all conditions of use (from
very dusty to wintry conditions etc.)
Wire mesh filter (green filter
N
housing) Use in extra-ordinary
conditions e.g. extremely wintry
conditions of use - such as powder
snow or drift snow. Rather
unsuitable in very dusty conditions.
When dry, STIHL filters attain a long
service life.
Always use STIHL filters dry
N
MS 880