Taking Care Of The Guide Bar - Stihl MS 382 Manual De Instrucciones

English
NOTICE
The saw chain must always be coated with oil.
17.2 Setting for increased oil deliv‐
ery rate
If necessary, the oil flow can be increased
beyond the standard setting.
► Press in end stop (2) using a suitable tool –
end stop is no longer functional, the oil flow
can be increased further
If the end stop has been pressed in, it remains in
this position.
To increase oil flow –
► turn the adjusting screw clockwise
To reduce oil flow –
► turn the adjusting screw counterclockwise
In adjustment range a, the oil tank may run dry
before the fuel tank, thus resulting in the saw
chain running dry.
► In adjustment range a, fill the fuel tank only
half full or refill the oil tank when the fuel tank
is approximately half empty
68

18 Taking Care of the Guide Bar

NOTICE
If an increased oil flow is no longer required,
reset the adjusting screw to the standard setting.
18 Taking Care of the Guide
Bar
2
► Turn the guide bar over – every time you
sharpen the chain and every time you replace
the chain – this helps avoid one-sided wear,
especially at the nose and underside of the
bar.
► Regularly clean the oil inlet hole (1), the oil‐
way (2) and the bar groove (3)
► Measure the groove depth – with the scale on
the filing gauge (special accessory) – in the
area used most for cutting
Chain type Chain pitch
Picco 1/4" P
Rapid 1/4"
Picco 3/8" P
Rapid 3/8"; 0.325"
Rapid 0.404"
If groove depth is less than specified:
► Replace the guide bar
The drive link tangs will otherwise scrape along
the bottom of the groove – the cutters and tie
straps will not ride on the bar rails.
1
3
Minimum
groove
depth
4.0 mm
4.0 mm
5.0 mm
6.0 mm
7.0 mm
0458-562-8721-B