Publicidad
Idiomas disponibles
Idiomas disponibles
EN
30
• Wipe the fi xed parts of the burner cup with a damp cloth and dry afterwards .
• Gently wipe the ignition device and fl ame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
• Before placing the burners back on the top plate, make sure that the injector is not
blocked.
Re-assemble the Auxiliary, Semi-Rapid, Rapid and Triple-Crown burners as
follows
1. Place the fl ame spreader ( 4 ) on to the burner cup ( 5 ) so that the ignition device
and the fl ame supervision device extend through their respective holes in the
fl ame spreader.The fl ame spreader must click into place correctly.
2. Position the burner lid ( 1,2,3 ) onto the fl ame speader ( 4 ) so that the retaining
pins fi t into their respective recesses.
Warning: Danger of fi re
Do not mix up the top and bottom.
The locating pins must fi t exactly into the notches.
Publicidad
