Safety Instructions; Section 1: Introduction; Tr5164 Installation Procedure - Tyco DSC Power Serie Manual De Instrucciones

Safety Instructions

• This equipment must be installed by Service Persons only (service person is defined as a person
having the appropriate technical training and experience necessary to be aware of hazards to which
that person may be exposed in performing a task and of measures to minimize the risks to that
person or other persons). It must be installed and used within an environment that provides the
pollution degree max 2, over voltages category II, in non-hazardous, indoor locations only.
• The installer is responsible for instructing the system user in regards to electrical safety precautions
when using a system which includes this equipment and also in regards to each of the following:
- Do not attempt to service this product. Opening or removing covers may expose the user to
dangerous voltages or other risks.
- Any servicing shall be referred to service persons only.
• Use authorized accessories only with this equipment.
• Secure the receiver to the building structure before applying power to the alarm controller.
Use adequate mounting means to secure the receiver to the building structure (e.g., plastic/metal
anchors and screws).Only UL listed devices can be used in UL listed installations: WS4904(P),
WS4945NA (residential burg applications only), WS4945CB (commercial burg applications only),
WLS912L-433, WS4939, WS4928 (Commercial burg applications only), EV-DW4927SS
(residential burg applications only).
TR5164-433 is UL listed for Residential Fire, Residential Burglary and Commercial Burglary
applications in accordance with the following standards:
UL985 Household Fire Warning System Units
UL1023 Household Burglar-Alarm System Units
UL1610 Central Station Burglar-Alarm Units
The TR5164-433 two-way wireless transceiver receives signals from wireless zones and wireless
keys, and provides information to the alarm controller it is connected to. This manual describes how
to install, program and maintain the TR5164.
Before installing:
1. Plan the placement and wiring of the security system (see the system installation manual).
2. Install the control panel, then install and enroll at least one keypad to use for programming.
3. Install and enroll any hardwired zone expander modules (PC5108).
Once the above steps are complete, program the TR5164 from a system keypad. Read the system
installation manual for more information.

1.1 TR5164 Installation Procedure

To install and set up the TR5164 and wireless devices:
1. Temporarily mount and wire the TR5164 module (Section 2.2, page 5).
2. Test the location for RF interference levels (Section 2.4, page 5).
3. Enroll a keypad (Section 3.1, page 6).
4. Enroll wireless devices (Section 3.2, page 6).
5. Complete zone and other programming on the system (Section 4.1, page 8).
6. Test the placement of all the wireless devices (Section 5.1, page 11).
7. Permanently mount the TR5164 receiver and wireless devices (Section 5.2, page 12).
For additional information on trouble conditions and battery replacement, see 6.1 "Trouble
Conditions" on page 13. For help with troubleshooting, see Section 7: "Troubleshooting" on
page 14.

Section 1: Introduction

3