7.7
Special function selection
7.7.1
Sleep function
The COOL and HEAT modes can be set during the nighttime
hours to avoid an excessive increase or decrease in the
temperature.
2
1
Fig. 7.16
Selection of SLEEP function.
Legend
1
SLEEP button
2
SLEEP function indicator
In order to activate:
• Select the desired operation mode (see section 7.5).
• Press the SLEEP button.
SLEEP function in COOL mode
The ambient temperature is increased by 1 °C per hour with
respect to the set temperature during the first two hours. This
new temperature is then maintained for the next 5 hours, then
gradually decreased again over the next two hours to reach the
original set temperature.
SLEEP function in HEAT mode
The ambient temperature is decreased by 1 °C every hour with
respect to the set temperature during the first two hours. This
new temperature is then maintained for the next 5 hours, then
gradually increased again over the next two hours to reach the
original set temperature.
SDH17-NW-U_EN - 05/14 - Saunier Duval
OPERATING INSTRUCTIONS
NOTE:
i
While the SLEEP function is activated, the fan
operates at low speed.
7.7.2
Timer On/Off function (Switch On/Switch
Off using timer)
The unit can be switched on/switch off using the timer.
Fig. 7.17
Selection of TIMER function.
Legend
1
TIMER ON/OFF function indicator
2
- / + buttons (increase/decrease)
3
TIMER ON button
4
TIMER OFF button
In order to program a switch on time for the unit:
• With the unit switched off, press the TIMER ON button. The
TIMER ON indicator starts to blink. Set the desired starting
time by pressing the - / + buttons. Press the TIMER ON
button again to confirm the desired starting time.
In order to program a switch off time for of the unit:
• With the unit switched on, press the TIMER OFF. The TIMER
OFF indicator starts to blink. Set the desired switch off time
of the unit by pressing the - / + buttons. Press the TIMER
OFF button again to confirm the desired switch off time.
In order to cancel:
• Press the TIMER ON or TIMER OFF button again.
1
2
3
4
EN
- 15 -