Stihl HT 56 C Manual De Instrucciones página 26

English
Warm engine (warm start)
5
Press in the choke knob (5) and turn
N
it to < at the same time.
Also use this setting if the engine has
been running but is still cold.
Cranking
Remove the chain guard.
N
Place the machine on the ground: It
N
must rest securely on the engine
support and the hook. If necessary,
rest the hook on a raised support
(e.g. a branch, mound or something
similar). Check that the chain is not
touching any object or the ground.
WARNING
Check that nobody is standing within the
working range of the pruner.
Make sure you have a safe and
N
secure footing.
24
Hold the unit firmly on the ground
N
with your left hand and press down
– do not touch the throttle trigger or
throttle trigger lockout.
NOTICE
Do not stand or kneel on the shaft.
Hold the starter grip with your right
N
hand.
Pull the starter grip steadily.
N
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking until the engine
N
runs.
As soon as the engine runs
Press down the throttle trigger
N
lockout and open the throttle – the
choke knob moves to the run
position F. After a cold start, warm
up the engine by opening the
throttle several times.
WARNING
Make sure the carburetor is correctly
adjusted. The saw chain must not move
when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
Move the stop switch in the direction
N
of 0 – the engine stops – release
the stop switch – it springs back to
the run position.
Other Hints on Starting
Engine stalls in cold start position g or
under acceleration.
Move the choke knob to < and
N
continue cranking until the engine
runs.
Engine does not start in warm start
position <
Move the choke knob to g and
N
continue cranking until the engine
runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
HT 56 C