Storing The Machine; Checking And Replacing The Chain Sprocket - Stihl HT 56 C Manual De Instrucciones

English
3
WARNING
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press the spark plug
boot (1) snugly onto the spark plug
terminal (2).
Do not use a spark plug with a
detachable SAE adapter terminal (3).
Arcing may occur that could ignite
combustible fumes and cause a fire.
This can result in serious injuries or
damage to property.
Only use resistor type spark plugs
N
with solid, non-threaded terminals
Installing the Spark Plug
Screw the spark plug into the
N
cylinder.
Press the boot firmly onto the spark
N
plug.
30

Storing the Machine

For periods of 3 months or longer
1
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
2
carburetor diaphragms sticking
together.
Remove chain and bar, clean and
N
spray with corrosion inhibiting oil –
always fit the chain scabbard over
the mounted cutting attachment.
If the unit is stored with the drive
N
tube disassembled: Fit the
protective cap on the drive tube to
avoid dirt getting into the coupling.
Thoroughly clean the machine – pay
N
special attention to the cylinder fins
and air filter.
If you use a biological chain and bar
N
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
Store the machine in a dry and
N
secure location Keep out of the
reach of children and other
unauthorized persons.
Checking and Replacing the
Chain Sprocket
Remove the chain sprocket cover,
N
chain and guide bar.
Replace the chain sprocket:
a
after using two saw chains or
–
sooner
if the wear marks (a) on the sprocket
–
are deeper than approx. 0.5 mm
(0.02 in) since this would reduce the
life of the chain. You can use a
gauge (special accessory) to check
the depth of the wear marks.
It is best to use two saw chains in
rotation with one sprocket.
STIHL recommends the use of original
STIHL chain sprockets.
HT 56 C