Bosch 0601072C02 Manual Original página 21

Digital laser measure
Data transmission
Bluetooth®
Operating frequency range
Max. transmission power
A) For measurements from the front edge of the measuring tool, this applies for high reflectivity of
the target (e.g. a white-painted wall), weak backlighting and 25 °C operating temperature. In addi-
tion, a deviation of ±0.05 mm/m must be taken into account.
B) For measurements from the rear edge of the measuring tool, applies to low reflectivity of the tar-
get (e.g. a dark-painted wall), strong backlighting and –10 °C to +45 °C operating temperature. In
addition, a deviation of ±0.15 mm/m must be taken into account.
C) In continuous measurement mode, the max. operating temperature is +40 °C.
D) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by con-
densation is expected.
E) Bluetooth® deactivated
F) When using Bluetooth® Low Energy devices, it may not be possible to establish a connection de-
pending on the model and operating system. Bluetooth® tools must support the GATT profile.
The serial number (11) on the type plate is used to clearly identify your measuring tool.
Assembly
Inserting/Changing the Batteries
Always replace all the batteries/rechargeable batteries at the same time. Only use
batteries/rechargeable batteries from the same manufacturer and which have the
same capacity.
When inserting the batteries, ensure that the polarity is correct according to the il-
lustration on the inside of the battery compartment.
Take the batteries out of the measuring tool when you are not using it for a pro-
u
longed period of time. The batteries can corrode and self-discharge during prolonged
storage in the measuring tool.
Operation
Start-Up
Never leave the measuring tool unattended when switched on, and ensure the
u
measuring tool is switched off after use. Others may be dazzled by the laser beam.
Bosch Power Tools
English | 21
GLM 50 C
Bluetooth® 4.2
(Classic and Low Energy)
2402–2480 MHz
2.5 mW
1 609 92A 5E2 | (29.01.2021)
F)