Publicidad
support@nextlevelracing.com
RIGHT HAND SHIFTER
MOUNT ASSEMBLY
01
Uninstall 4 x Ratchet Handles and 2 x Seat Slider Assemblies.
02
Uninstall 2 x M8 40mm Bolts and M8 Washers connecting the Right Base to the Rear Base.
Uninstall the End Cap and Cable Management Clip (if installed).
03
Install 2 x Full Width T-Nuts into the top and bottom channels of the Right Base.
Red dots show T-Nuts placement.
PARTS:
Note: For Left Hand Shifter
• • NIL
Mount skip to Step 16.
PARTS:
• • NIL
PARTS:
• • 2 x M8 Full Width T-Nuts
or
• • 2 x M8 Regular T-Nuts
(Carbon Grey Elite Cockpits only)
Note: Use Regular T-Nuts if installing onto
Carbon Grey F-GT Elite Cockpit.
6
6
04
Install the Bolts, Washers, Cable Management Clip (optional), and End Cap previously uninstalled in
Step 02.
05
Install 2 x Seat Slider Assemblies and 4 x Ratchet Handles previously uninstalled in Step 01.
Note: Use Regular T-Nuts if installing onto
Carbon Grey F-GT Elite Cockpit.
06
Uninstall the End Cap at the top of the Right Wheel Post. Install 4 x Full Width T-Nuts.
Red dots show T-Nuts placement. Reinstall the End Cap.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2 x M8 40mm Bolts
• • 2 x M8 Washers
• • 1 x End Cap (40 x 80)
• • 1 x Cable Management Clip
(optional)
PARTS:
• • 4 x Ratchet Handles
• • 2 x Seat Slider Assemblies
PARTS:
• • 4 x M8 Full Width T-Nuts
or
• • 4 x M8 Regular T-Nuts
(Carbon Grey Elite Cockpits only)
7
7
Publicidad
