Publicidad
support@nextlevelracing.com
(
)
TOP FACE
(
)
OUTSIDE FACE
(
)
INSIDE FACE
(
)
BOTTOM FACE
25
Install 10 x Full Width T-Nuts into the Shifter Arm. Red dots show T-Nuts placement.
B)
A)
26
A) Install 2 x Corner Brackets on the top and bottom of the Shifter Arm. Bolt through and secure with 4 x M8 Bolts and Washers.
B) Install Shifter Arm Support Bracket (Left) to the bottom of the Shifter Arm. Bolt through and secure with 2 x M8 Bolts and Washers.
27
Align the Shifter Arm Assembly from Step 26 with the T-Nuts previously installed in Steps 21 and 23.
Bolt through and secure with 6 x M8 Bolts and Washers.
PARTS:
• • 10 x M8 Full Width T-Nuts
• • Shifter Arm
PARTS:
• • 2 x Corner Brackets
• • Shifter Arm
• • Shifter Arm Support
Bracket (Left)
• • 6 x M8 16mm
• • 6 x M8 Washers
Bolts
PARTS:
• • 6 x M8 16mm Bolts
• • 6 x M8 Washers
14
14
28
Align the mounting slot holes in Shifter Plate with T-Nuts previously installed in Step 25.
Bolt through and secure with 4 x M8 Bolts and Washers.
29
Install End Caps.
ANGLE AND POSITION
ADJUSTMENT
A)
B)
B)
C)
C)
A) Loosen the Bolts securing the Shifter Plate. Adjust to the desired angle and position, tighten the Bolts to lock in place.
B) Loosen the Bolts securing the Shifter Arm to the Shifter Arm Support and the Wheel Post. Adjust to the desired height, tight-
30
en the Bolts to lock in place.
C) Loosen the Bolts securing the Shifter Support Arm to the Left Base. Loosen the bolts securing the Shifter Arm to the Wheel
Post. Adjust forward or backward to the desired position, tighten the Bolts to lock in place.
15
15
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
• • Shifter Plate
PARTS:
• • 2 x End Caps (40 x 40 Angled)
• • 2 x End Caps (40 x 80 Angled)
PARTS:
• • NIL
Publicidad
