Publicidad
support@nextlevelracing.com
19
Install the Bolts, Washers, Cable Management Clip (optional), and End Cap previously uninstalled in
Step 17.
20
Install 2 x Seat Slider Assemblies and 4 x Ratchet Handles previously uninstalled in Step 16.
Note: Use Regular T-Nuts if installing onto
Carbon Grey F-GT Elite Cockpit.
21
Uninstall the End Cap at the top of the Left Wheel Post. Install 4 x Full Width T-Nuts.
Red dots show T-Nuts placement. Reinstall the End Cap.
PARTS:
• • 2 x M8 40mm Bolts
• • 2 x M8 Washers
• • 1 x End Cap (40 x 80)
• • 1 x Cable Management Clip
(optional)
PARTS:
• • 4 x Ratchet Handles
• • 2 x Seat Slider Assemblies
PARTS:
• • 4 x M8 Full Width T-Nuts
or
• • 4 x M8 Regular T-Nuts
(Carbon Grey Elite Cockpits only)
12
12
22
Align the Shifter Support Connecting Plate with the T-Nuts previously installed in Step 18.
Bolt through and secure with 2 x M8 Bolts and Washers.
(
OUTSIDE FACE
23
Install 4 x Full Width T-Nuts into the Shifter Arm Support.
Red dots show T-Nuts placement.
24
Align the T-Nuts installed to the inside face of the Shifter Arm Support in Step 23 with the mounting
slot on the Shifter Support Connecting Plate. Bolt through and secure with 2 x M8 Bolts and Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • Shifter Support Connecting
Plate
• • 2 x M8 20mm Bolts
• • 2 x M8 Washers
PARTS:
• • 4 x M8 Full Width T-Nuts
• • Shifter Arm Support
) (
)
INSIDE FACE
PARTS:
• • 2 x M8 20mm Bolts
• • 2 x M8 Washers
13
13
Publicidad
