Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Symptom
No power.
• The power cord is disconnected.
• The battery is discharged.
No picture on the LCD
• The video cable is not connected securely.
or TV (including video
• The MODE selection is not set correctly.
from another unit).
• LCD mode is set to OFF.
• The TV is not set to receive DVD signal
output.
• The equipment connected with the audio cable
No sound.
is not set to receive DVD signal output.
• The audio cables are not connected
securely.
The unit does not start
• An unplayable disc is inserted.
playback.
• The Rating level is set.
No response when but-
• Some discs prohibit certain operations.
tons are pressed.
• The Remote Control is too far from the
The Remote Control
unit.
does not work properly.
Cause
• Plug the power cord into the wall outlet securely.
• Recharge the battery.
• Connect the video cable into the jacks securely.
• Set the MODE correctly.
While you are viewing video from other equipment,
set the MODE to A/V IN mode.
• Select a LCD mode other than OFF.
• Select the appropriate video input mode on the TV
so the picture from the unit appears on the screen.
• Select the correct input mode of the audio receiver
so you can listen to the sound from the unit.
• Connect the audio cable into the jacks securely.
• Insert a playable disc. (Check the disc type and
Regional code.)
• Cancel the Rating function or change the rating level.
• "
" may appear on the screen during operation.
• Operate the Remote Control within about 23 ft
(7 m).
41
Correction
Publicidad
