Publicidad
Idiomas disponibles
Idiomas disponibles
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Fire or Explosion Hazard. Never
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
PRE- -OPERATION CHECKS
1. Sweep and dust mop the floor.
2. Check battery meter charge level to ensure
batteries are fully charged (See CHARGING
BATTERIES).
3. Check that pads or brushes are installed.
4. Check that squeegee is installed.
5. FaST scrub mode: Make sure that the solution
tank is filled with clear cool water only. All
conventional cleaning agents/restorers must be
drained and rinsed from solution tank. Check
FaST--PAK agent level, replace carton as needed.
OPERATING THE MACHINE
NOTE: If your machine is equipped with the FaST
Option, refer to page 11 for additional operation
procedures.
1. Adjust control grips to a comfortable operating
height (three settings). Squeeze two levers
together, located under console, to raise and lower
control grips (Figure 16).
2. Lower squeegee. Depress thumb lever on
squeegee lift lever to lower (Figure 17).
Speed Scrub 2701/3301 (07- -04)
FIG. 16
Home Find... Go To..
FIG. 17
3. Lower scrub head. Depress top brush lift foot
pedal forward to lower (Figure 18).
FIG. 18
4. Turn on the main, vacuum and brush switches.
NOTE: The brush motors will not start until control
grips are rotated.
5. Activate solution flow (for conventional scrubbing
only). Push solution flow lever slightly forward to
activate. The further the lever is pushed forward
the more solution will flow. Push completely
forward for maximum flow. Solution will
immediately begin to flow once lever is activated
(Figure 19).
FIG. 19
OPERATION
11
Publicidad
