Reset Function; Manual Settings; Time Zone Setting - TFA 35.1147 Instrucciones De Uso

TFA_No. 35.1147_Anleitung 06.10.2017 9:33 Uhr
COLORIS – Wireless weather station
• During night-time, the atmospheric interference is usually less severe and reception is possible in most cases. A single daily reception is ade-
quate to keep the accuracy deviation under 1 second.
7. Operation
• Important: Please do not press any keys during signal reception of DCF time and transmitter.
• Press and hold the +/RESET MIN/MAX button in setting mode for fast mode.
• The device will automatically quit the setting mode if no button is pressed for 15 seconds.
• With the SET button you can toggle between time and date in normal mode.

7.1 Manual settings

• Press and hold the SET button in normal mode.
• 0 (default) appears on the display and flashes.
• Press +/RESET MIN/MAX button to adjust the time zone.
• Press the SET button again to do the settings in the following sequence: The DCF reception (On - default), the year, the month, the day, the
hours, the minutes and the reset to factory settings (rst). Press the +/RESET MIN/MAX button to adjust it.
• Confirm with the SET button.
• Once the DCF time signal is successfully received and the DCF reception is activated, the manually set time is overwritten.

7.1.1 Time zone setting

• You can make the time zone correction (-12/+12) in setting mode.
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from the DCF time (e.g.
+1=one hour plus).
28
Seite 15
COLORIS – Wireless weather station
7.1.2 DCF reception
• By default, the DCF reception is activated (On) and after successful reception of the DCF signal no manual adjustment is necessary.
• Press the +/RESET MIN/MAX button if you want to deactivate the DCF reception (OFF).

7.1.3 RESET function

• In the setting mode, you can reset the weather station to the factory setting (rst).
• Press and hold the +/RESET MIN/MAX button until "rst" stops flashing.
8. Alarm function
• Press the ALM button in normal mode, to enter the alarm mode.
• ALM and 00:00 (default) or the last adjusted alarm time appear on the display.
• Press and hold the ALM button. The alarm symbol will appear and the hour digit will be flashing. Press +/RESET MIN/MAX button to adjust
the hours.
• Confirm the setting with the ALM button and set minutes in the same way.
• Press the ALM button again.
• The current time and the alarm symbol appear on the display.
• When the adjusted alarm time is reached, the alarm rings.
• The alarm symbol flashes.
• Press any button to stop the alarm.
• If the alarm is not stopped manually, the alarm tone automatically turns off after two minutes and will be reactivated at the same set time in
the following day.
29