Holmatro GCT 51 ST EVO 3 Serie Manual página 46

EN
• Close the blades.
WARNING
Stop immediately if the blades are out of line. Danger of serious injury and of serious damage
to the equipment.
6.5.1 Cutting with CT 5160
To enable better cutting in specific situations the spreading tips can be removed.
WARNING
Prevent operation of the tool when you remove or connect of accessoiries.
Avoid cutting with the blade tips only. (Fig. 12)
Refer to Fig. 8
• Push (A) and pull (B) the pin out untill it locks.
• Remove the spreading tips from the blades (C).
6.6 Squeezing
• Open the blades of the tool.
• Place the blade tips over the object to be squeezed.
• Position the load 25 mm from the end of the tips. Use full width of the tips.
• Close the blades of the tool.
CAUTION
When using tool model (G)CT 5160, always use the spreading tips. Make sure the lock pins
stay locked.
6.7 Spreading
CAUTION
When using tool model (G)CT 5160, always use the spreading tips. Make sure the lock pins
stay locked.
6.7.1 Initial opening is sufficient
• Close the blades completely.
• Place both blade tips between the parts to be spread.
• Position the load 25 mm from the end of the tips. Use full width of the tips.
• Force the parts apart by opening the blades.
6.7.2 Initial opening is insufficient
• Open the blades.
• Place one blade tip in the opening. Use full width of the tip.
• Close the blades until the material is clamped.
• Bend the clamped material out of the way.
• Repeat this procedure until there is sufficient space to place both blade tips.
• Force the parts apart by opening the blades.
46
All manuals and user guides at all-guides.com
916.001.650_002 GCT 51** (ST) (STA) EVO 3