Troubleshooting - Haier HLP141E Manual Del Usuario

English

TROUBLESHOOTING

Check your problem by using the chart below (If problems occur, please pull out
the plug before examining) and try the solutions for your problem. If the dryer
still does not work properly, contact Haier customer service center or the nearest
authorized service center.
Symptom
Dryer won't work
Dryer won't heat
Garments won't dry
enough
Drum won't turn (The
four indicator lights
of Cycle button are
on at the same time)
WARNING!
Never Overload the dryer.
Never put wet clothing washer spin cycle did not extract.
If troubleshooting is not resolved, unplug unit and call customer service.
19
Possible Cause
• No power to machine?
• Power plug not in the wall outlet?
• Front door not properly shut?
• Heating Temperature was not
set for Timed Dry?
• Is temperature indicator LED
indicating "Air Dry"?
• Outside venting ducting is
blocked?
• The exhaust filter is blocked?
• Washer didn't extract enough
water?
• Overloaded dryer with too
many garments?
• Clothes not sorted to proper
cycle selection?
• Is the front door closed?
Possible Remedy
• Plug in Power Cord
• Reset circuit breaker or
replace fuses
• Close the front door
Press in the Power/ON/
OFF or Start?Pause button
• Reset the 'Temp' button till
the indicator light indicates
'High' or 'Low', and the LED
is on
• Change Temp. settings to
High or Low: Air Dry works
without heat
• Make sure outside vent is
not blocked
• Remove and clean Exhaust
filter
• Make sure washer spin
cycle is operating properly
• Reduce the amount of
garments loaded in dryer
• Select the right drying cycle
for normal, heavy or delicate
laundry loads.
• Close front door and Press
the Start/Pause button