Descargar Imprimir esta página

Tecfrigo ISOLA MSERVICE BM Instalación Y Uso página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
Operator's guide:
1. Unpacking instructions
2. Mounting the protective glass cover
3. Cleaning the internal basin
I
4. Cover and external cleaning
5. Holders for containers
UK
6. Support shelves
7. Filling and emptying the basin
D
8. Connection to the mains
9. Controls
E
F
!
WARNINGS
NL
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
P
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it. . It
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
S
installation of the appliance should be carried out by a qualified electrician or other competent person.
4. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
DK
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs.
6
7. The manufacturers of this appliance accept no responsibility for the consequences of misuse in
FIN
contravention of these safety instructions. It further reserves the right to carry out improvements without
prior notice.
B
GR
!
Our products are for internal use only do not install outside restaurants, shops
CZ
EE
1. UNPACKING INSTRUCTIONS
LV
CARDBOARD BOXES 1a. Cut surrounding tape. Remove the cardboard package by sliding it upwards.
WOODEN CRATE 1b.
LT
between the appliance and pallet or crate.
the appliance on a flat, level surface.
H
7
it. . Sort out the packaging materials in order to facilitate disposal. . The appliance can be locked in
place by engaging the wheel brakes (see fig. 1).
M
2. MOUNTING THE PROTECTIVE GLASS COVER
PL
1
. Unpack the glass panels. . Insert the glass side panels in the special U-brackets you will find in the
upper section of the cabinet. . Tighten the brackets' screws.
insert the steel ceiling lamp assembly. . Fix the lamp assembly with the screws supplied.
SK
lamp cables with the profiles provided. . Assemble the front panel, inserting it into its seat (see figure 2).
SLO
3. CLEANING THE INTERNAL BASIN
1.
Remove the protection film from the stainless steel parts.
neutral detergents. . Remove obstructions in front of the float hole
4. Open the tap located on the rear side of the machine to drain any residual water (see fig. 3).
4. COVER AND EXTERNAL CLEANING
1. Refrain from using detergents containing alcohol or solvents that could irremediably damage the cover
and compromise its transparency. . Use only a soft damp sponge. . Use specific cleaning products
generally available on the market to clean the wooden surfaces, which should anyway be water-based
emulsions, free of all solvents. . Place the front glass panel in its rest position for easier cleaning. . Dry
with a clean cloth (see figure 4).
5. HOLDERS FOR CONTAINERS
1.
Remove the protection film from the holders.
3. Place the shorter holders on the special slots on the longer holders. Different arrangements are
available for different container sizes and positions. . Position the containers in accordance to your
requirements (see fig.5).
6. SUPPORT SHELVES
To fix the support shelves in a horizontal position, grasp the lower edge of the shelves and turn upwards
(A).
Push the edge close to the tank downwards
5
Remove the nails from the wooden crate with care. . Insert forks of forklift truck
6.
2
3
5
3
2
4
Operator's guide
10. Checking correct operation
11. Cleaning of the bain-marie basin
Maintenance manual (Page 48):
1. Replacing the lamp
2. Sliding doors
3. Wiring diagram
3.
Lift the appliance.
4.
Make sure there is nothing left in the package before disposing of
4.
Having assembled both glass panels,
7
2.
Clean the basin with a soft sponge and
2.
Place the longer holders on the long sides of the basin.
4
(B)
until each shelf is blocked into position (see fig. 6).
6
3
2
Remove the pallet or crate. . Place
8
6.
(A)
and the drainage hole
3
2
5
Protect the
(B).
5

Publicidad

loading

Este manual también es adecuado para:

Isola mservice hot