Operating The Machine; Starting The Diesel Engine; Starting The Propane Engine - Advance CS7000 Serie Instrucciones De Uso

OPERATING THE MACHINE

The CS7000 is a rider-type automatic fl oor sweeping and scrubbing machine. It is designed to sweep up debris, lay down cleaning solution, scrub
the fl oor, and vacuum dry all in one pass. The sweeping and scrubbing operations can also be performed separately.
The controls were designed with one touch operation in mind. For single pass scrubbing the user can simply depress one switch and all scrub
functions on the machine will be enabled. For sweeping, the operator can simply depress one switch and all sweeping functions will be enabled.
NOTE: Bold numbers or letters in parentheses indicate an item illustrated on pages 6-10.

STARTING THE DIESEL ENGINE

1 Turn the key switch (A) clockwise to the RUN (ON) position. The glow plugs will activate for 10 seconds as indicated by the glow plug icon on
the display. If the engine is already warm, turn the key switch to the start position to crank the engine. If the engine is cold, wait for the glow
plug icon to turn off before cranking the engine. The engine should start immediately. If the engine does not start within 15 seconds release
the key, wait for approximately one minute and repeat the above steps.
2 Let the engine run at IDLE speed for fi ve minutes before using the machine.
STARTING THE LP ENGINE
1 Open the service valve on the LP fuel tank.
2 Turn the Ignition Key Switch (A) clockwise to the START position and release it as soon as the engine starts. If the engine does not start after
cranking for 15 seconds, release the key, wait for 1 minute, then try again.
3 Let the engine run at "IDLE" speed for 5 minutes before using the machine.
The Engine Speed (RPM) will automatically adjust depending upon load. Use the Drive Pedal (37) not the Engine Speed Switch (K) to
control the speed of the machine. The speed of the machine will increase as the pedal is pushed closer to the fl oor. Do not press the Drive Pedal
(37) until the engine has started.
SPEED SWITCH (K) ON LP AND DIESEL MODELS:
There are three engine speed settings that can be selected by the engine speed switch (K) on the control panel.
1 "Idle" (1700 RPM – both LP and Diesel). Use for warm up and cool down. The engine speed switch light will be off.
2 "Run" (2500 RPM - LP) (2200 RPM - Diesel). Automatically adjusts to this RPM for transporting, sweeping only or vacuum only operations.
The engine speed light will be on.
3 "Maximum Power" (2700 RPM - LP) (2400 RPM - Diesel). Automatically adjusts to this RPM for scrubbing only or scrubbing and sweeping.
The engine speed light will be on.
4 To select between Idle and Run press and release the engine speed switch.
5 To select the Maximum Power speed, fi rst set the speed to Run. Then press and hold the engine speed switch for 2 seconds. To go back to
Run speed, press the switch again.
6 The CS7000 has an automatic idle feature that will reduce the engine speed to idle when the foot pedal (37) has been in the neutral position
for 20 seconds or more. The selected engine speed will automatically resume when the foot pedal is moved from neutral. If the engine speed
switch (K) is pressed while in idle-override, the automatic idle feature will be temporarily disabled until the next time the foot pedal is moved
from the neutral position. This can be useful during troubleshooting or if it is desired to let the machine run at full speed for warming up.
SPEED SWITCH (K) ON BATTERY MODELS:
While scrubbing the maximum speed is limited. To override the scrub speed limit press the Speed Switch (K), this enables scrubbing at
maximum transport speed.
ENGLISH / A-17
FORM NO. 56041979 - CS7000 - A-17